IV. Diatonic Harmony, Tonicization, and Modulation
Strengthening Endings with V7
John Peterson
Key Takeaways
- This chapter introduces how composers add a seventh to the dominant to strengthen its pull toward the tonic. There are three ways a V7 can resolve to tonic:
- The default resolution: where all active notes resolve according to their tendencies.
- Incomplete V7: where the fifth is omitted from the V7 and the V7‘s root is doubled instead to create a complete tonic.
- Leading-tone drop: where the leading tone in a complete V7 leaps down to sol ([latex]\hat{5}[/latex]) to create a complete tonic.
The phrase in perfect authentic cadence (PAC) similar to those we saw and wrote in the Introduction to Harmony, Cadences, and Endings chapter. Here, however, the V chord contains an extra note, fa ([latex]\hat{4}[/latex]), that transforms it from a major triad into a dominant seventh chord. Since the seventh adds dissonance (and therefore instability) to the chord, it strengthens the pull of the V chord toward I. Compare the sound of the excerpts in
ends with a
The Default Resolution of V7 to I
When the notes of a complete V7 chord resolve according to their typical tendencies, we end up with a tonic triad that has three roots and one third—no fifth (
and ). This is a completely normal, expected, and common resolution of V7 to I. It’s okay to leave out the fifth here since it doesn’t provide essential information about the chord. By contrast, the root and third are essential: the root determines the chord’s name, and the third determines its quality.The resolution in
, where re ([latex]\hat{2}[/latex]) goes up to mi ([latex]\hat{3}[/latex]), is very uncommon, and such an unusual doubling in the tonic chord (two roots, two thirds) usually leads to voice-leading problems. We suggest avoiding this kind of resolution.
To resolve V7 to I using a default resolution:
- Write the entire bass: sol to do ([latex]\hat{5}[/latex]–[latex]\hat{1}[/latex])
- Write the entire soprano by choosing an active note to place in the soprano over V7, then resolving that note according to its tendency.
- If you are writing in minor, remember to use ti ([latex]\uparrow\hat{7}[/latex]), not te ([latex]\downarrow\hat{7}[/latex]) in V7 to make the chord major!
shows the tendencies for active notes in V7.
- Fill in the inner voices by asking “what do I have, what do I need, and what is the tendency of those notes?”
[table id=38 /]
Alternative Resolutions of V7 to I
Sometimes a composer may want the tonic chord to be complete rather than the incomplete chord that occurs in the default resolution. Two alternative resolutions of V7 make it possible to create a complete I. Note that the steps for writing remain the same as for the default resolution: write the entire bass, write the entire soprano choosing an active note over V7, then fill in the inner voices together as a pair by asking “what do I have, what do I need, and where do those notes go?”
Incomplete V7
and show a resolution where the fifth has been omitted from the V7, allowing that chord to resolve to a complete I. When we omit the fifth, we need to select a note to double in order to retain our four-voice texture. The only note we can double is the root, since doubling ti ([latex]\uparrow\hat{7}[/latex]) or fa ([latex]\hat{4}[/latex]) would create parallel octaves when both voices resolve according to their tendencies ( and ).
Leading-Tone Drop
It’s also possible to create a complete I from a complete V7, but in order to do so, we have to allow a tendency tone to move somewhere other than its expected resolution. [1] Here, ti ([latex]\uparrow\hat{7}[/latex]) drops down to sol ([latex]\hat{5}[/latex]) in an inner voice. This works because: (1) ti ([latex]\uparrow\hat{7}[/latex]) is not a dissonant note; (2) ti ([latex]\uparrow\hat{7}[/latex]) is in an inner voice, so it’s not too noticeable; and (3) ti ([latex]\uparrow\hat{7}[/latex]) is the closest note that can move to sol ([latex]\hat{5}[/latex]) in the tonic without causing parallels.
shows how this is possible using a leading-tone drop.
Two things are worth emphasizing here:
- Use the leading-tone drop only in the alto or tenor voice to hide the fact that it’s not resolving as expected.
- The leading tone always leaps down to sol ([latex]\hat{5}[/latex]), never to mi ([latex]\hat{3}[/latex]), which is further away than sol ([latex]\hat{5}[/latex]).
Summary
half cadences (HCs). V7 is much less common in a HC since the HC is already unstable, and adding a seventh makes it that much more unstable. Since such a cadence more often appears in Romantic music, Janet Schmalfeldt (2011, 202) has termed HCs involving V7 the “19th-century HC.”
summarizes the three possible ways to resolve V7–I. You may notice that we have not discussed how V7 works in
- Schmalfeldt, Janet. 2011. In the Process of Becoming: Analytic and Philosophical Perspectives on Form in Early Nineteenth-Century Music. New York: Oxford University Press.
- Strengthening Endings with V7 (.pdf, .docx, spotify playlist). Asks students to write and resolve V7 chords and provide analysis of cadences in select passages.
- This is a term we first heard from Nancy Rogers at Florida State University. Some people describe this phenomenon as a "frustrated leading tone," but we believe that "leading-tone drop" better describes the technique. ↵
In tonal music, a note that has a tendency to move to a specific note in the following chord, usually a step up or down. Also called a "tendency tone."
A V–I cadence that ends with do (1̂) in the melody. Both harmonies must be in root position.
A triad whose third is major and fifth is perfect.
A seventh chord in which the triad quality is major and the seventh quality is minor.
A kind of inconclusive cadence that occurs when a phrase ends on V. Occasionally, particularly in Romantic music, the final chord of a half cadence will be V⁷.